Make kites

Build a kite

Kite making is hard work. Please follow the instructions carefully and check if your measurement at each stage. If you do this as good as we built your kite will fly!

Making context
Build a skeleton, a wooden rod, carbon fiber or plastic with a thin saw cut to proper length. Try cutting a smooth and uniform check - if the wand into a large force may be broken. Wand of the sandpaper to smooth the edges of your use.

Wooden sticks

Connections for connectivity you can switch the yarn tightly, use glue or adhesive tape. For kite with angular corners of your steel or plastic (knee, three way or four way) which are used in plumbing aquarium or air conditioner use. Plastic fittings are tight, but steel can be the appropriate angle (for Badbadktan) can be bent.

Connections

Connection to sail
For connecting polyethylene, paper or cardboard, you can use Scotch tape. The objects to be put on both sides for more strength to hit the tape.

Connection to sail
If you must use components with nylon thread and needle, sew. Try the edges of the 10mm and put on the small Cook and stir constantly. For additional strength, two parallel rows of Cook and sew a 5mm gap.

Connection to sail

Making paper containers (envelopes)

Wand by paper containers (envelopes) in the upper corners, and side effects are fixed. These containers can easily create.

Paste paper containers
Cut a triangle from the PE firm. Try measuring the side corner of the kite.

Paste the chamber
Side of the tape to fasten the sail to the corners of the triangle (or container) to use.

Paste the chamber
The other end of the chamber to make it to the edge is smooth. At the end of the tape can be sure.

Paste the chamber

Suture housing
A bar (25 * 90 mm) cut from nylon. As of the middle and sew up.

Suture housing
Set sail on the sides of the chamber to be consistent on the corner. Scallop-shaped cross (X) is to increase strength.

Suture housing

Container holding the control loop

Some of the container holding the kite is necessary to be used. To make it look like the following.

The control loop


The control loop

In the following "corner case" and "container holding the ring" to sail is attached to the connection of the polyester yarn is used.

Kite

Connection string to the ring

When the kite is necessary to make use of two main yarn. To help the lumbar nodes, the connection string to a rod end is closed and to help Larak nodes, the connection string to the "control loop" is connected to the other side. The flight of the yarn to knit Larak to "control ring is connected. These nodes are shown below.

 
Nodes Larak


 
Lumbar nodes

Nodes Larak


Lumbar nodes

Nodes Larak


Lumbar nodes

Nodes Larak


Lumbar nodes

طراحی فروشگاه: شرکت ایده گرافیک
فروش و پخش عمده اسباب بازی، بادبادک و کایت در ایران © 2008

هرگونه كپي برداري پيگرد قانوني دارد

kites.ir Real PR